Cut Controls

Sets the printer control method during cutting.

Item			Description	Refer to
Cutting Options			Configures the cutting operation mode and detailed settings.
	Operation Mode		Selects the printing and cutting operation mode.
		Print & Cut	Select to perform printing and cutting continuously.	Performing Cutting Only/Printing and Cutting Continuously
		Cut & Print	This method uses printing data including cutting lines to perform cutting first followed by printing. Performing cutting first reduces the drying time compared to cutting after printing. However depending on the conditions of the media after cutting, there may be an effect on printing.	Performing Printing after Cutting
		Print Only	Select to perform printing only.
		Cut Only	Select to perform cutting only.
	Cut All Paths		All paths will be recognized as cutting lines and will be cut regardless of whether they are drawn with the spot color (CutContour).	Performing Cutting Only/Printing and Cutting Continuously
	Cut Image Boundaries		Cuts the border of the job regardless of whether a cutting line is present.
	Return to Origin After Print		Pulls back the media after printing.
	Return to Origin After Cut		Returns the media to the origin (the position before cutting) after cutting.
	Cut Passes		Specifies the Cut Passes.
	Cutting Conditions Settings		Configures printer cutting conditions such as the blade force.	Step 2: Configuring the Cutting Conditions
		Cutting Speed	Enter Cutting Speed in cm/s.
		Cutting Force	Enter Cutting Force in units of gram-force.
		Blade Offset	Enter the blade offset value (the distance between the tip and the center of the blade) in millimeters. Enter the offset value for the blade being used.
	Execute PREFEED Operation		Feeds out media according to the size of the data before starting output, thereby preventing the media from being pulled out with excessive force. The media is then pulled back to the output-start location.
Perforated Cut Controls			Configures the perforated cutting at image boundaries for printing data including cutting lines.	Performing Perforated Cutting at Image Boundaries
	Perform Perforated Cut for Image Boundaries		This can be selected and the boundary can be changed to perforated cutting when Cut Image Boundaries is selected.	Performing Perforated Cutting at Image Boundaries
	Cutting Conditions Settings		Configures the detailed perforated cutting conditions.
		Perforation Length	Sets the length of the part that will be cut through to the backing paper.
		Perforation Force	Sets the blade force for the part that will be cut through to the backing paper.
		Half-cut Length	Sets the length of the part where just the sticker surface will be cut, leaving the backing paper.
		Half-cut Force	Sets the blade force for the part where just the sticker surface will be cut, leaving the backing paper.

Feedback