Adjusting the Printing Position in the Layout Area

This section explains how to set the printing position while checking it in the layout area in the Job Settings window. Use this function to rearrange nested jobs, to change the order of multiple print runs to cut the same number of prints, and similar situations.
VW6_PositionSetting
Procedure
  1. In the job list, double-click the job.
    The Job Settings window appears.
  2. Click .
  3. Click .
  4. Click the preview image in the layout area.
    The preview image of the selected job is highlighted with a light blue border (A).
    VW6_PositionSetting1
    IMPORTANT Select multiple jobs by clicking the preview images while holding down the Shift key or by dragging the mouse pointer over the preview images.
  5. Drag the selected preview image to a new location in order to set its printing position.
    Jobs cannot overlap each other. If you drag a preview image on top of the preview image of another job, a red box (B) appears as shown in the figure.
    VW6_PositionSetting2

    In the layout area, you can use the layout editing tools to adjust the printing position.

  6. Click OK.
    You can check the job's printing position in the layout window of the top screen.