Cutting All Lines
-
Click
for the queue folder to be used.
The Queue Properties window appears. -
Click
.
-
From the Operation Mode list, select one of the following.
- Print & Cut
- Cut & Print
- Cut Only
- Select the Cut All Paths check box.
-
Set Perforation Length, Perforation Force, Half-cut Length, and Half-cut Force.
-
Perforation Length: Length of the part that will be cut through to the backing paper
-
Perforation Force: Cutting force for the part that will be cut through to the backing paper
-
Half-cut Length: Length of the part where just the sticker surface will be cut, leaving the backing paper
-
Half-cut Force: Cutting force for the part where just the sticker surface will be cut, leaving the backing paper
-
-
Click OK.
MEMO
- The source data of the job is an EPS file.
- A cutting line has been drawn around the border.
If both of the above conditions are met, additional settings are required. If you do not configure these additional settings, it may not be possible to cut a part of the border. Configure the settings shown below.
- In the Queue Properties window, click
.
- Enter a value in Margin under EPS.
-
If you scale the image in the Queue Properties or Job Settings window, the size of the margin will also be scaled.
-
When you add a job to the job list, the margin set with Margin is automatically added within the range specified by the border.
-
-
Click
.