Cleaning Error (Drain Bottle)

This message appears when one of the following situations is detected.
  • The drain bottle was removed or became full while Light Choke Cleaning was in progress.
  • The drain bottle was removed or became full during initial ink filling.
Operation cannot be continued. Perform the following operations.
  1. Discard the discharged fluid in the drain bottle, and then attach this bottle again.
  2. Check that the ink cartridges are inserted and that there is sufficient ink.
  3. Switch the sub power off and back on.
  4. Perform Light Choke Cleaning.
MEMO If the printer stopped partway through Light Choke Cleaning, perform Ink Renewal, and then perform Light Choke Cleaning again.