Correcting the Reading Sensor

Depending on the characteristics of the media, such as reflectivity and colors, the machine may not be able to read the media width. In such cases, correct the sensor for reading the media.
Procedure
  1. Set up the media.
  2. Tap Panel_Icon_Menu.
  3. Tap Media Settings - Other Media Settings - Multi Sensor Adjustment.
  4. Tap Execute.
  5. Perform the operations shown below according to the Adjustment Result.
    • If Successful is displayed on the operation panel, proceed to the next procedure.
    • If Failed is displayed on the operation panel, the following causes are possible, so take countermeasures and redo the correction.
      Cause Countermeasures

      The lighting in the room where the printer is installed or vicinity of the printer is too bright.

      Adjust the lighting in the room.
      Correction failed for some reason. Redo the correction.

      Crop marks cannot be recognized due to the characteristics (reflectivity and colors) of the media.

      		 To cut with crop marks, try the following.
      There is ink on the multi sensor because, for example, the media strikes it immediately after printing. Contact your authorized dealer.
  6. Tap Panel_Icon_Home to return to the home screen.