Outputting a Job

From the operation panel, perform VersaWorks and Queue Folder via Roland DG Connect Hub, and then print the job.

First, check the following items:

  • Roland DG Connect Hub version 3.2.5 or later is installed on the computer where VersaWorks is installed.
  • The VersaWorks version is 7.6.0 or later.
  • Roland DG Connect Hub has started, and you have signed in.
  • VersaWorks is running.
  • The printer is ready to print (media has been set up).
Procedure
  1. Tap Panel_Icon_Menu.
  2. Tap Job Management - Direct Printing.
    The VersaWorks list (VersaWorks nicknames that were set with Connect Hub) is displayed.
  3. Tap the desired VersaWorks.
    A list of the queue folders is displayed.
  4. Tap the desired queue folder.
    The job list is displayed.
    Tap JobHistory_reset to update the job and get the latest job status information.
  5. Tap the job you want to print.
  6. Tap MG2_PanelIcon-EditBlue.
  7. Enter the print count.
    IMPORTANT

    The print count is output with the print count set in VersaWorks as a unit of one.

    If the print count in VersaWorks is set to two times, the actual output count according to the instructions on the operation panel is as follows.

    • With "One time" specified on the operation panel: The print count is output twice.
    • With "Two times" specified on the operation panel: The print count is output four times.
  8. Tap Execute.
    The job is printed.