Jump to main content
Setup Guide
Setup Guide
  • Introduction
  • Installation
  • Appendix
INDEX
INDEX
  1. Home
  2. Installation
  3. 4. Software Setup
  4. Step 3: Registering the Machine to Roland DG Connect Hub
  • Introduction
  • Installation
    • 1. Assembly and Ink Filling
    • 2. Installing the Cutting Tool
    • 3. Configuring the Computer's Network Settings
    • 4. Software Setup
      • Step 1: Downloading and Installing Roland DG Connect Hub
      • Step 2: Creating a New Roland DG Connect ID
      • Step 3: Registering the Machine to Roland DG Connect Hub
      • Step 4: Installing VersaWorks from Roland DG Connect Hub
      • Step 5: Configuring VersaWorks Settings
  • Appendix

Step 3: Registering the Machine to Roland DG Connect Hub

Refer to the procedure below to register the printer to Connect Hub.

https://support.rolanddg.com/hc/en-us/categories/6469527154585-Roland-DG-Connect

  • Introduction
  • Installation
    • 1. Assembly and Ink Filling
    • 2. Installing the Cutting Tool
    • 3. Configuring the Computer's Network Settings
    • 4. Software Setup
      • Step 1: Downloading and Installing Roland DG Connect Hub
      • Step 2: Creating a New Roland DG Connect ID
      • Step 3: Registering the Machine to Roland DG Connect Hub
      • Step 4: Installing VersaWorks from Roland DG Connect Hub
      • Step 5: Configuring VersaWorks Settings
  • Appendix

Feedback

1 2 3 4 5
NO YES

Feedback

Thank you

VG4/R1-260407

Copyright © 2026 Roland DG Corporation  
https://www.rolanddg.com/

Setup Guide