The media could not be detected automatically. Manually set the printing area.
This message appears when media with high reflectance is set up. Manually set the printing area.
Procedure
- Tap OK on the screen displaying the above message.
- Tap Change.The Set the right edge of the printing area within the area specified by the pinch rollers. screen appears.
- Hold down to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B) from the left edge of the right pinch roller.
- Tap OK.The Set the left edge of the printing area within the area specified by the pinch rollers. screen appears.
- Hold down to move the center of the blade (A) approximately 2 mm (0.08 in.) to the inside (B) from the right edge of the left pinch roller.
- Tap OK.The set left and right positions are applied to the Printing Area (Width).
- Tap OK.