Step 4: Correcting the Misalignment of Printing and Cutting

Procedure
  1. Tap AP-640_Panel_Icon_MENU.
  2. Tap Media Settings - Cutting Settings - Print & Cut Position Adjustment.
  3. Tap Execute next to Printing Test 1 (Misalignment Check).
    Printing Test 1 is printed and cut. The test pattern is printed at each edge of the media.
    MEMO

    If the media is tilted, the positions at the edges will be misaligned. You can also adjust for misalignments due to the media being tilted by printing the test pattern at each edge.

  4. Check the result of Printing Test 1.
    Check whether the printing position (shaded part) and the cutting position (red line) are aligned. An example of the printing position and the cutting position being misaligned is shown in the following figure.

    F indicates the feed direction of the media (the feed direction) and S indicates the direction of print head movement (the scan direction).



    If the printing position and the cutting position are aligned, no corrections are necessary.

    If the printing position and the cutting position are not aligned, proceed to the next procedure.

  5. Tap Execute next to Printing Test 2 (Correction Values).
    Printing Test 2 is printed and cut.
  6. Check the correction values from the Printing Test 2 condition.

    The point where the cutting line (A) intersects the correction-value scale (B) is the correction value. In the following figure, the correction value is "−0.3."

    Check the media feed direction (the feed direction) and the direction of print head movement (the scan direction).



  7. Set the correction values in the feed direction of the media (the feed direction) and the direction of print head movement (the scan direction).
    1. Tap AP-640_Panel_Icon_MINUS or AP-640_Panel_Icon_PLUS next to Correction Value (Feed) to set the correction value in the feed direction of the media (the feed direction).
    2. Tap AP-640_Panel_Icon_MINUS or AP-640_Panel_Icon_PLUS next to Correction Value (Scan) to set the correction value in the direction of print head movement (the scan direction).
  8. Tap Save.
    The correction values are saved.
  9. Tap Execute next to Printing Test 1 (Misalignment Check).
    Printing Test 1 is printed and cut. If the printing and cutting lines are aligned, adjustment is complete. If further adjustment is needed, tap AP-640_Panel_Icon_MINUS or AP-640_Panel_Icon_PLUS next to Correction Value (Feed) and Correction Value (Scan) to fine-tune the printing and cutting position, and then Save the values.
    MEMO
    Default settings
    • Correction Value (Feed) (correction value of the media feed direction): 0.00 mm
    • Correction Value (Scan) (correction value of the print head movement direction): 0.00 mm
  10. Tap AP-640_Panel_Icon_HOME to go back to the original screen.