Step 5: Installing the Drain Bottle

Procedure
  1. Remove the drain pad.
    Discharged fluid used in the inspection when the printer was shipped may remain. Exercise caution.

    VG3-640_InstallDrainbottle00

  2. Install the drain funnel.
    Screw the drain funnel all the way into the hole where the drain pad was attached.
    IMPORTANT Use caution to turn the bottle without applying excessive force.

    VG3-640_InstallDrainbottle0

  3. Insert the drain bottle stand into the grooves , and then slide it in the direction indicated in the figure .


    Insert the hooks (A) into the grooves (B), matching the status indicated in the figure.


  4. Connect the drain bottle stand connector to the unit.


  5. Stand up the drain bottle stand so it is vertical , and then slide it in the direction indicated in the figure .
    Stand up the drain bottle stand until the hooks come completely free from the grooves.


  6. Fully tighten the two bolts to secure the drain bottle stand.


  7. Install the drain bottle in the bottle stand.