Switching Off the Print Heater and Dryer Together

This setting is useful when you want to switch off the media heating system collectively, such as when performing only cutting. Setting the heater settings "POWER" to "OFF" will cause temperature settings of the print heater and dryer to become impossible.
  1. Press FUNCTION.
  2. Press ▼ several times to display the screen shown below.


  3. Press ▶ to display the screen shown below.


  4. Press ▶.
  5. Press ▲ or ▼ to select "OFF."


  6. Press ENTER to confirm your entry.
    The settings for the print heater and dryer are turned off.
  7. Press FUNCTION to go back to the original screen.
    MEMO:
    • Default setting: ON
    IMPORTANT:

    When this is set to OFF, the heater will not turn on even if the heater temperature is set in the included software RIP.