Setting the Dryer Temperature

Setting the temperature of the dryer appropriately makes the ink dry fast.

  • With the default settings, simply switching on the power does not make the dryer warm up to the set temperature. The temperature rises to the set temperature when the media is loaded correctly and SETUP lights.

  • Depending on the usage environment, the temperature of the print heater may become higher than the set temperature, but this does not represent a problem.

  • Temperature settings are not possible when heater settings "POWER" is OFF.

  1. Press FUNCTION.
  2. Press ▼ several times to display the screen shown below.


  3. Press ▶ once, and then press ▼ twice to display the screen shown below.


  4. Press ▶ to display the screen shown below.


  5. Press ▲ or ▼ to select the temperature.
    When ink drying is poor, raise the temperature. Note, however, that a temperature that is too high may degrade the media or cause it to wrinkle.

    You can also set the temperature to OFF. When set to OFF, the dryer does not operate at all.

  6. Press ENTER to confirm your entry.
  7. Press FUNCTION to go back to the original screen.
    MEMO:

    • Default setting: 45°C (113°F)

    • You can also make this setting in the software RIP. When you have made the setting in the software RIP, the software RIP's setting is used.