1. Clean the print head caps.

Procedure
  1. Remove any media.
  2. Press [FUNCTION].
  3. Press [▶] once, and then press [▼] several times to display the screen shown below.


  4. Press [ENTER].
    "NOW PROCESSING.." is displayed and the print head moves to the left end of the platen. After that, the screen shown below appears.


    IMPORTANT:

    Do not press [ENTER] at this stage. Press [ENTER] after cleaning is complete. If you press [ENTER] at this stage, wait for the screen to change as shown in the following figure, and then press [ENTER] again.





  5. Open the right cover.


  6. Touch the location shown in the figure to discharge any static electricity.


  7. Moisten the cleaning stick with the cleaning liquid.
    IMPORTANT:

    Be sure to use one of the included cleaning sticks.



  8. Clean the locations shown in the following figure.
    Be especially careful to clean away any fibrous dust (lint).


  9. When you have finished cleaning, close the right cover.