3. Finish setup.

Procedure
  1. Line up the edges of the media with the centers of the holes of the left and right media clamps.


  2. Close the front cover.
  3. Press [ENTER].
    When you press [ENTER], the cutting carriage moves and detects the width of the media. This operation is called initialization. When initialization ends, [SETUP] on the operation panel lights, and the printable width is displayed on the screen.
    IMPORTANT

    Remove when not using roll media.

    Do not leave roll media loaded on the machine for a long period of time. Be sure to remove and store the media when not in use. Leaving the roll media loaded on the machine for a long period of time will cause the media to sag, which may deteriorate the printing quality and may also lead to motor errors.

  4. If you have moved the machine to load the media, return the machine to its original position and fix the casters in place after loading the media.
    1. Orient the casters so that they face forward.
    2. Lock the casters.
    3. Use caster holders to fix the casters in place.