Changing the Dryer Temperature

Setting the temperature of the dryer appropriately makes the ink dry fast. An applicable application is changing the set temperature of registered media.
  • With the default settings, the temperature rises to the Standby Heater Temperature when the power turns on. On completion of media setup, the temperature rises to the set value.
  • Depending on the usage environment, the temperature of the dryer may become higher than the set temperature, but this does not represent a problem.
  • Temperature settings are not possible when Heater Power accessed from Media Settings - Heater Settings - Heater Temperature is off.
Procedure
  1. Set up the media.
  2. Tap the following location on the home screen.
    TY_Panel_Home-heater
  3. The Heater Temperature screen appears.
  4. Check that the Heater Power check box is selected.
  5. Tap AP-640_Panel_Icon_MINUS or AP-640_Panel_Icon_PLUS to set the Dryer temperature.
    When ink drying is poor, set the temperature to a higher value. Note, however, that a temperature that is too high may degrade the media or cause it to wrinkle.
  6. Tap Save to confirm your entry.
  7. Tap AP-640_Panel_Icon_HOME to go back to the original screen.
    MEMO
    • Default setting: 45°C (113°F)
    • You can also make this setting in the software RIP. When you have made the setting in the software RIP, the software RIP's setting is used.