Replacing the Print Head Caps

The print head caps seal the nozzle surfaces of the print heads, preventing these surfaces from drying out and preventing dust from adhering to them.

When it is time to replace the print head caps, the message The time for cap replacement has arrived. appears. In this situation, replace the print head caps.

WARNING

Be sure to perform operations as specified by the instructions, and never touch any area not specified in the instructions.

Sudden movement of the machine may cause injury.

Required items
CapAssy




Print head cap Cloth (that is not fluffy) Cleaning stick
IMPORTANT

Take care to prevent ink from adhering to the operation panel.

Procedure
  1. When the message The time for cap replacement has arrived. appears, tap OK.
  2. Remove any media.
  3. Tap VG3_Panel_Icon_NOTE_1note to display the messages.
  4. Tap The time for cap replacement has arrived..
  5. Tap Execute.
  6. When the confirmation screen appears, respond to the on-screen instructions, and then tap OK.
    The print head carriage moves to the left side of the machine.
  7. Follow the instructions on the operation panel to replace the print head caps.
    • Tap VG3_Panel_Icon_LEFT_blue or VG3_Panel_Icon_RIGHT_blue to check the procedure.
    • If you complete the work without viewing the instructions, tap Finish All.
    IMPORTANT

    Ink may drip from the removed print head cap. Exercise caution to prevent this fluid from soiling your hands or the floor.

    To prevent ink from adhering to your hands, the machine, or the floor, cover the bottom surface of the removed print head cap with paper towels or something similar.

  8. When the print head cap replacement is finished, tap Finish All.
  9. When Close the cover. appears, close the right cover.
    When you close the right cover, you are returned to the original screen.
  10. Tap AP-640_Panel_Icon_HOME to go back to the original screen.