Step 4: Connect the cables.

WARNING

Connect to an electrical outlet that complies with this machine's ratings (for voltage, frequency, and current).

Incorrect voltage or insufficient current may cause fire or electrical shock.

WARNING

Do not use with any electrical power supply that does not meet the ratings displayed on the AC adapter.

Use with any other power supply may lead to fire or electrical shock.

WARNING

Never use any AC adapter or power cord other than those included with the machine.

Use with any other power supply may lead to fire or electrical shock.

Procedure
  1. Insert the printer connection cable into the printer connector on the printer unit.
    On the printer unit, the printer connector is located:
    • At the bottom of the front panel of the VF2-640, VG2-640/540, VG-640/540.*1
    • At the bottom of the front panel of the SG2-640/540/300, SG-540/300.
    • On the rear panel of the LEC2-300.
    • On the side panel of the LEC2-640/330, MG-640/300, UG-641.

    Insert the cable into the printer connection terminal on the main unit
  2. Insert the printer connection cable into the printer connector on the control box.

    Plug the cable into the printer connection terminal of the control box
  3. Connect the AC adapter (A) to the AC adapter jack (B) of the control box.
    Bundle the excess cable with a cable clamp (large).
    MEMO Place the AC adapter inside the right slider stay.
  4. Connect the power cord to the AC adapter, and then connect the power cord to an electrical outlet.
    Fix the power cord in place with a cable clamp (small).
    Figure 1. Printer side
    Connect the AC adapter to the AC adapter jack