Step 1: Assembling the Take-up Unit

Procedure
  1. Attach the arm (B) to the rail slider (A) and fix it with the arm retaining screw (C).
    Orient the rail slider so its riveted side (D) is on the side opposite the arm retaining screw.

    InstallRailSliderToArm
  2. Place the right slider stay (A) and the left slider stay (B) apart from each other with enough space between them to fit the machine. (*1)
    SetSliderStayRandL
    *1 64-inch model: Approx. 1.9 m (74.80 in.)
    54-inch model: Approx. 1.7 m (66.93 in.)
    30-inch model: Approx. 1.0 m (39.37 in.)
  3. Fix the rail slider in place on top of the right and left slider stays.
    1. Align the rail slider slit (A) with the left slider stay protrusion (B), and then place the rail slider on top of the left and right slider stays.

      FixRailSlidertoSliderStayRandL
    2. Align the edges of the rail slider with the edges of the left and right slider stays.
    3. Fix the rail slider in place using the bolts with washers (large).
      FixRailSlidertoSliderStayRandL_2
  4. Install mounting bracket A (A) and fully tighten the bolts with washers (large) connecting the rail slider and the left and right slider stays.

    SetMountingBracketAandTightenIt