Removing Media from the Take-up Unit

When output is complete, separate the media, take up the media manually, and then remove the media.

WARNING

Handling roll media is an operation that must be performed by 2 persons or more, and care must be taken to prevent falls.

Attempting to lift heavy media in a manner that taxes your strength may cause physical injury. Also, if dropped, such items may cause injury.

Procedure
  1. Lower the dancer roller toward the rear.

    VG3-640_PushDancerBar_WithMedia

  2. Close the front cover.
  3. With the media held down, tap AP-640_Panel_Icon_SHEETCUT Sheet Cutting on the operation panel.
  4. Select Sheet Cutting and tap Execute.
    IMPORTANT
    Give Attention to the Media Composition
    • For some types of media, separation is not possible.
    • Some types of media may remain on the platen after separation. If the media remains on the platen, remove it by hand.
  5. Use the MANUAL switch to take-up the media.
    When using the FORWARD settingWhen using the BACKWARD setting

    Take up the media with [FORWARD].


    VG3_TakeupManually_FORWARD

    Take up the media with [BACKWARD].


    VG3_TakeupManually_BACKWARD

  6. While supporting the media from below, loosen the securing lever on the left media holder.

    VG3-640_LoosenLever_TU_withMedia

  7. With the media supported, pull the paper tube and media from the end cap.

    AP-640_RemovePaperTubefromTU