1. Replacing the Blade

Procedure
  1. Remove any media.
  2. Tap AP-640_Panel_Icon_MENU.
  3. Tap Maintenance - Blade Replacement.
    The Blade Replacement screen appears.
  4. Tap Execute.
    The cutting carriage moves to a position where blade replacement is possible.
  5. When Open the front cover. appears, open the front cover.
    MEMO The procedure is displayed on the operation panel.
    • Tap VG3_Panel_Icon_LEFT_blue or VG3_Panel_Icon_RIGHT_blue to check the procedure.
    • If you complete the work without viewing the instructions, tap Finish All.
  6. Detach the blade holder.


  7. Replace the blade.
    1. Press the pin (A) to push out the old blade (B).
    2. Insert a new blade (C).
      Orient the tip of the blade (D) correctly.


  8. Install the blade holder into the cutting carriage.


  9. Tighten the screw.
    Tug the blade holder upward to make sure it does not come loose.


  10. When the replacement of the blade is complete, tap Finish All.
  11. When Close the cover. appears, close the front cover.
    When you close the front cover, you are returned to the original screen.
  12. Tap AP-640_Panel_Icon_HOME to go back to the original screen.