Step 1: Assembling the Stand

Procedure
  1. Place the caster on the stand leg.

    Place the stand leg with the tabletop plate (A) facing down, and then place the caster on top of the stand leg. The casters have no particular front and rear orientation.



  2. Use eight bolts to secure the caster.
    1. Temporarily tighten the bolts in the four lower locations and then in the four locations on the sides.


    2. Fully tighten the bolts in the four lower locations.


    3. Fully tighten the bolts in the four locations on the sides.


  3. Assemble the opposing stand leg by following the same procedure from step 1 to step 2.
  4. Position the left and right stand legs parallel to each other and separated by approximately 1,550 mm (61 in.) for the 54-inch model or approximately 930 mm (36.6 in.) for the 30-inch model.

    Position the legs so that the L-shaped brackets face the inside and the side of the tabletop plate with the hole (A) faces down for each leg.



  5. Place the stand stay on the stand legs.

    Position the stand stay with attachment holes (A) toward the casters.



  6. Use eight bolts to secure the stand stay.
    1. Temporarily tighten the bolts in the four locations indicated with A followed by the four locations indicated with B.
    2. Fully tighten the bolts in the four locations indicated with A.
    3. Fully tighten the bolts in the four locations indicated with B.
      Tighten the bolts securely. Loose bolts may cause the stand to wobble.


  7. Set the stand upright.
    IMPORTANT Be sure to perform this operation with two workers, each one holding one stand leg. If only one worker performs this operation, the stand stay may bend.