Step 2: Securing the Print Heads and the Flat Table Using Retainers

Use the retainer that was attached to the inside of the machine during its installation.
  1. Open the front cover.
    IMPORTANT:

    Be sure to hold the handle of the front cover and keep holding it until the cover is completely opened or closed.

    If you do not open and close the front cover gently, it may break or you may be injured.

  2. Remove the stored retainers A () and B ().
    Make sure to remove all five retaining screws ().


  3. Using the five retaining screws (), secure the print heads with retainer A () and the flat table with retainer B ().