Step 3: Securing the Print-head Carriage in Place Using the Retainer

Use the retainer that was stored during the installation of the machine.
  1. Open the panel cover.
    Remove the screw on the top of the panel cover, and then pull out the panel cover in the direction indicated by the arrow.

  2. Move the print-head carriage to the position indicated in the picture.
    Move the print-head carriage by hand.

    CAUTION:

    When moving the print-head carriage by hand, be sure to hold the specified position.

    Moving it by holding positions other than that specified may deform and damage the cover.



    : Position to hold with your hand
  3. Secure the print-head carriage in place using retainer C ().


  4. Push the print-head carriage to the right side.
    Push the print-head carriage until an audible click is heard.
    CAUTION:

    When moving the print-head carriage by hand, be sure to push the specified position.

    Moving it by pushing positions other than that specified may deform and damage the cover.



    : Position to push with your hand
  5. Close the panel cover.


  6. Close the front cover.
    The machine is now ready to be moved.