Table Height Error

Check the table height. Press [OK].

This message is displayed when the head gap sensor interferes with the object during non-printing operations.

Check to see if the object does not exceed the size that can be mounted. If it exceeds the size, mount an object that is the size that can be mounted.

Tap OK to clear the message.

Operation was stopped because the media height is abnormal. Press [OK].

Printing stops when an abnormality in the height of the object is detected during printing.

The clearance between the print surface and print head exceeds the specified value. It is possible that the diameter and length settings for the object are different from the actual object, that loading of the object failed, or that there was large deviation from the rotation center. Investigate the cause and resolve the problem.

Tap OK to clear the message.