Raising and Lowering Pool Tables

Procedure
  1. Turn on the power if it is off.
    Turning the Power On
  2. Click the DEBUG tab in the upper-right corner of the window.

    move-table_1
  3. Click icon_ctrl_cursor.
    The Motor Control window appears.

    move-table_2
  4. Click the pool whose table you want to raise or lower, and then specify the amount to move the table.
    1. Click the pool whose table you want to raise or lower.

      move-table_3

      1. Supply pool, 2. Molding pool, 3. Reuse pool

    2. Enter the amount of movement from the current position in Step, and then click icon_up or icon_down.

      move-table_6
      MEMO To move a relatively long distance, icon_slc_next_layer or icon_slc_previous_layer shown in the figure below can also be clicked. Note that the movement will continue until the stop button is clicked when using this method.

      move-table_4