Removing Fixture Material from the Gutter (PB-600)

Under the pool, there is a gutter that is used to catch fixture material. Clean this gutter if it is filled with fixture material.

Procedure
  1. Open the cover.
    Open both sides.

    PB-600_cleaning_gutter_0
  2. Pull the gutter out.
    There are protrusions below the gutter, which make it impossible to pull the gutter out toward you.

    PB-600_cleaning_gutter_1
    Pull the gutter out from the side without a cable carrier.

    PB-600_cleaning_gutter_1-2
    1. Push the gutter inside while lifting it up.

      PB-600_cleaning_gutter_2
    2. Move to the opposite side of the gutter, and then pull it out toward you.

      PB-600_cleaning_gutter_3
  3. Clean up the fixture material in the gutter with a vacuum cleaner.
    Pull out the entire gutter before cleaning it up.
  4. After cleaning the gutter, return it to its original position.
  5. Open the maintenance cover.
  6. Pull a gutter out.

    PB-600_cleaning_gutter_4
  7. Clean up the fixture material in the gutter with a vacuum cleaner.
  8. After cleaning the gutter, return it to its original position.
  9. In the same way, pull out the gutter on the opposite side, and then remove the fixture material from it.
  10. Close the maintenance cover.