Adjust Manual Cleaning Tool Position

If this is your first time installing the machine, be sure to adjust the position of the manual cleaning tool.

Also adjust the position of the manual cleaning tool when the manual cleaning tool has been replaced.

Procedure
  1. Open the front cover.
  2. Remove any object already on the machine.
    If the object is already set up, cancel the setup in Utility.
  3. Lower the machine guide to its lowermost point.
    1. Loosen the guide fixing screw.
      RotaryGuide_ScrewLoosen
    2. Lower the guide to its lowermost point.
      RotaryGuide_Lower
    3. Tighten the guide fixing screw.
      RotaryGuide_ScrewTighten
  4. On the Utility home screen, click BN2_Utility_Icon_MENU.
  5. Click Preferences.
  6. Click Execute under Position Adjustment - Adjust Manual Cleaning Tool Position.
    Execute cannot be clicked when the object is set up.
  7. Follow the instructions on the Utility window to adjust the position of the manual cleaning tool.
    MEMO The pointer used to adjust the manual cleaning tool position always irradiates the initial position.
    1. When the message "This starts manual cleaning tool position adjustment" appears, click OK.
    2. Attach the manual cleaning tool.
      MEMO

      Refer to "Manual Cleaning" in the BD-12/BD-8 User's Manual to attach the manual cleaning tool.

      https://downloadcenter.rolanddg.com/BD-8

    3. Click OK.
    4. Click Up, Down, Left, or Right to align the pointer to the manual cleaning tool reference position.
      BD-8_AdjustMCTool
    5. Click OK.
    6. When the message Remove the manual cleaning tool. appears, remove the manual cleaning tool.
    7. Click OK.
  8. Click Close to return to the original screen.