Setting the Starting Imprinting Height
For material that is easily damaged, set the height at which to start imprinting and detach the head cap before starting imprinting.
With the head cap detached, the head cannot track the height of the material, so it will not be possible to imprint on curved surfaces.
If you're performing imprinting while using a head cap, there is no need to perform the work in this section.
-
Press the Power/Movement button.
The head moves and stops with the tip of the head cap in the center of the table.
-
Loosen the knob.
Rotate the knob counterclockwise once. Then you can move the stopper.
-
Push the stopper down to the lowest position, and then tighten the knob.
Align the center of the knob with the top of the triangle directly below it (), and then secure the stopper.
-
Press the Power/Movement button.
The head moves to the left rear.
MEMOWhile supporting the head, detach the head cap.
Putting your fingers on the projecting rim of the head cap makes it easier to detach the cap.