Removing the Retainer
Retainers are attached to the machine to protect it from vibration during transportation. When installation is complete, remove these.
This work must be performed before connecting the power cord.
The power turning on inadvertently during these operations may result in pinched hands or other injury.
- Make sure to remove all the retainers. Any that remain may cause faulty operation or breakdown when the power is switched on.
- Store the retainers because they are needed again when transporting the machine.
- For transportation of this machine, contact your authorized dealer.
2.5 mm (0.1 in.) and 3.0 mm (0.12 in.) hexagonal wrenches are included. Use the 2.5 mm (0.1 in.) hexagonal wrench for retainers A and B, and the 3.0 mm (0.12 in.) hexagonal wrench for retainers C and D.
-
Open the front cover and maintenance cover.
MEMO
Be sure to hold the handle of the front cover and keep holding it until the cover is completely opened or closed.
If you do not open and close the front cover gently, it may break or you may be injured.
-
Using a hexagonal wrench, remove retainers A, B, C, and D.
-
Install retainers A, B, C, and D, which you have removed, at the positions indicated in the figure for storage.
Use the bolt removed in step 2.MEMO
To prevent the loss of the screws that are not being used, store them in the screw holder ().
-
Remove retainer E and install it with different orientation.
Rotate retainer E by 180° and install it at the position that hides the gear.
-
Remove the retaining tape and retainer F.
-
Close the front cover and the maintenance cover.
MEMO
Be sure to hold the handle of the front cover and keep holding it until the cover is completely opened or closed.
If you do not open and close the front cover gently, it may break or you may be injured.