Outputting a Job from the Operation Panel

Follow the procedure below to operate VersaWorks from the operation panel and output a job. This Direct Printing is performed via Roland DG Connect Hub. The following conditions must be met.
  • The Roland DG Connect Hub version is 3.2.6 or later.
  • You are signed in to Roland DG Connect.
  • Roland DG Connect Hub and VersaWorks are running.
Procedure
  1. Set up the media.
  2. Tap Panel_Icon_Menu.
  3. Tap Job Management - Direct Printing.
    The list of computer names (the names of computers on which VersaWorks is installed and that have been set in Connect Hub) is displayed.
  4. Tap the name of the target computer.
    A list of the queue folders is displayed.
  5. Tap the desired queue folder.
    The job list is displayed.
    Tap JobHistory_reset to update the job and get the latest job status information.
  6. Tap the job to output.
  7. Tap MG2_PanelIcon-EditBlue.
  8. Enter the print count.
    MEMO

    The print count is output with the print count set in VersaWorks as a unit of one.

    If the print count in VersaWorks is set to two times, the actual output count according to the instructions on the operation panel is as follows.
    • With "One time" specified on the operation panel: The print count is output twice.
    • With "Two times" specified on the operation panel: The print count is output four times.

  9. Tap Execute.
    The job is output.