Jump to main content
Setup Guide
Setup Guide
  • Introduction
  • Installation
  • Appendix
INDEX
INDEX
  1. Home
  2. Installation
  3. 5. Software Setup
  4. Step 4: Registering the Machine to Roland DG Connect Hub
  • Introduction
  • Installation
    • 1. Assembling the Machine
    • 2. Filling with Ink
    • 3. Installing the Cutting Tool
    • 4. Setting the Computer's Network
    • 5. Software Setup
      • Step 1: Creating a Roland DG Connect Account
      • Step 2: Downloading and Installing Roland DG Connect Hub
      • Step 3: Signing in to Roland DG Connect Hub
      • Step 4: Registering the Machine to Roland DG Connect Hub
      • Step 5: Installing VersaWorks from Roland DG Connect Hub
      • Step 6: Configuring VersaWorks Settings
  • Appendix

Step 4: Registering the Machine to Roland DG Connect Hub

Refer to the procedure below to register the printer to Connect Hub.

https://support.rolanddg.com/hc/articles/44190367491481

  • Introduction
  • Installation
    • 1. Assembling the Machine
    • 2. Filling with Ink
    • 3. Installing the Cutting Tool
    • 4. Setting the Computer's Network
    • 5. Software Setup
      • Step 1: Creating a Roland DG Connect Account
      • Step 2: Downloading and Installing Roland DG Connect Hub
      • Step 3: Signing in to Roland DG Connect Hub
      • Step 4: Registering the Machine to Roland DG Connect Hub
      • Step 5: Installing VersaWorks from Roland DG Connect Hub
      • Step 6: Configuring VersaWorks Settings
  • Appendix

Feedback

1 2 3 4 5
NO YES

Feedback

Thank you

MG2/R1-260924

Copyright © 2026 Roland DG Corporation  
https://www.rolanddg.com/

Setup Guide