Step 2: Check the results of the cutting test and adjust the cutting conditions.

Procedure
  1. Open the front cover.
  2. Check the results of the cutting test.
    CutTestPrint4
    Check item Result Setting item Adjustment
    Check the shape. The cut shape is distorted. Cutting Speed Reduce
    Peel off the circle. The square also peels off. Blade Force Increase
    Some uncut areas remain. Cutting Speed Reduce
    Peel off the square. The blade leaves faint traces on the backing paper. Blade Force No change
    The blade trace is indistinct. Increase
    The blade trace is too deep and cuts into the backing paper. Reduce
    Check the shape of the square you have peeled off.


    		The corners are not rounded and do not have "horns." Blade Offset No change


    		The corners are rounded. Increase


    		The corners have "horns." Reduce
  3. Tap AP-640_Panel_Icon_MINUS or AP-640_Panel_Icon_PLUS to change the settings.
    Display screen (cutting conditions) Setting details Default settings
    Blade Force Set the force (pressure) of the blade. 50 gf
    Cutting Speed Set the speed of cutting. 30 cm/s
    Blade Offset

    Set the blade offset. Enter the listed offset value for the blade.

    The offset value for the included blade is 0.250 mm (9.8 mil).

    		 0.250 mm (0.010 in.)
    Rise Movement Speed Set the blade's up speed during cutting (the speed at which the blade travels when it moves to the next cutting line after cutting one cutting line). If the media comes loose during no-load feed and the blade damages the surface of the media, reduce the speed. 30 cm/s
  4. Tap Save to confirm your entry.