Setting the Activation Interval for Sleep Mode (Power-saving Feature)

This setting is used to set how long it should take until the machine goes into sleep mode (the state in which the power-saving feature is working) when no print data is received and no operations are performed for a continued length of time.
Procedure
  1. Press [MENU].
  2. Press [▼] several times to display the screen shown below.


  3. Press [▶].
  4. Press [▼] several times to display the screen shown below.


  5. Press [▶] twice to display the screen shown below.


  6. Press [▲] or [▼] to select the time.
    You can set the value in units of 15 minutes from 15 minutes to 120 minutes.
  7. Press [ENTER] to confirm your entry.
  8. Press [MENU], then [◀] to go back to the original screen.
    MEMO:

    When "SLEEP SETTING" is set to "DISABLE", the machine does not switch to sleep mode, so this setting is ignored.