3. Attach the object to be printed on.

Point:

With the LEF2-300D, height detection is not possible if the spacer table is not used and an object to be printed on with a thickness of 100 mm (3.94 in.) or less is loaded. For objects to be printed on with a thickness of 100 mm (3.94 in.) or less, use the spacer table.

IMPORTANT:

Be sure to hold the handle of the front cover and open and close it gently.

Procedure
  1. Check that the following screen is displayed.


    If this screen is not displayed, check that nothing has been placed on top of the flat table, and then hold down [SETUP] for 1 second or more.

    The flat table will come forward into a position in which the object to be printed on can be set up.

  2. Open the front cover.
  3. Secure the object to be printed on.
    A jig might be required according to the shape of the object to be printed on.
    The following figure shows an example of using jigs to fit the shape of the object to be printed on.


  4. Close the front cover.