Jump to main content
1. Basic Handling Methods
2. Output Method
3. Optimizing Quality and Efficiency
4. Maintenance
5. Troubleshooting Methods
6. Appendix
Index
Search
Home
5. Troubleshooting Methods
2. Machine Problems
The Printer Unit Does Not Run
1. Basic Handling Methods
2. Output Method
3. Optimizing Quality and Efficiency
4. Maintenance
5. Troubleshooting Methods
1. Print Quality Problems
2. Machine Problems
The Print Heads Do Not Move
The Printer Unit Does Not Run
Is the power switched on?
Is [SETUP] lit?
Are any covers open?
Is the top menu displayed?
Is [PAUSE] lit?
Has the ink run out?
Is a message displayed on the screen?
Are the cables connected?
Is the status LED for the LAN cable connector lit in green?
Are the LAN settings correct?
Did the software RIP end abnormally?
Is the temperature of the room too low?
The Flat Table Does Not Move
The Head Gap Sensor Does Not Detect the Object to Be Printed on
It Is Not Possible to Check the Amount of Discharged Fluid (Round Drain Bottle)
3. Messages on the Operation Panel
6. Appendix
The Printer Unit Does Not Run
Is the power switched on?
Is [SETUP] lit?
Are any covers open?
Is the top menu displayed?
Is [PAUSE] lit?
Has the ink run out?
Is a message displayed on the screen?
Are the cables connected?
Is the status LED for the LAN cable connector lit in green?
Are the LAN settings correct?
Did the software RIP end abnormally?
Is the temperature of the room too low?
1. Basic Handling Methods
2. Output Method
3. Optimizing Quality and Efficiency
4. Maintenance
5. Troubleshooting Methods
1. Print Quality Problems
2. Machine Problems
The Print Heads Do Not Move
The Printer Unit Does Not Run
Is the power switched on?
Is [SETUP] lit?
Are any covers open?
Is the top menu displayed?
Is [PAUSE] lit?
Has the ink run out?
Is a message displayed on the screen?
Are the cables connected?
Is the status LED for the LAN cable connector lit in green?
Are the LAN settings correct?
Did the software RIP end abnormally?
Is the temperature of the room too low?
The Flat Table Does Not Move
The Head Gap Sensor Does Not Detect the Object to Be Printed on
It Is Not Possible to Check the Amount of Discharged Fluid (Round Drain Bottle)
3. Messages on the Operation Panel
6. Appendix
