4 Adjust the misalignment of the ink landing position.

  1. Press ◀ to select SET.


  2. Press ENTER to confirm your entry.
    Printing of the test pattern starts.

    You can select NEXT and press ENTER to skip the current menu and proceed to the next menu.

  3. Press ENTER.


  4. View the printed test pattern, and then determine the correction value.
    Select the value that gives the least misalignment between the two lines. In the case of the following figure, select "-3." When you cannot choose between two sequential numbers, select a value that is between them (you can set correction values in units of "0.5").


  5. Press ▲ or ▼ to select the correction value.


  6. Press ENTER to confirm your entry.
  7. Press ◀ to select SET.


  8. Press ENTER to confirm your entry.
    The test pattern is printed again. Check that the gap and overlap are the smallest for the figure indicated by "" (that is, the current correction value). If the gap and overlap are smaller for another figure, return to step 5. to perform the setting again.

    If you do not need to change the correction value, press ENTER again.

  9. Press ▶ to select DONE.


  10. Press ENTER to confirm your entry.
  11. Press ▶ to select NEXT.


  12. Press ENTER to confirm your entry.