4 Check the adjustment results.

  1. Press ◀, ▶, ▲, or ▼ to move the cutting carriage.
    Align the center of the blade with the position where the cutting test can be performed on the media used for the cutting and printing test.


  2. Press FUNCTION to display the screen shown below.


  3. Press ENTER.
    The base point is set.
  4. Press FUNCTION.
  5. Press ▼, then ▶ to display the screen shown below.


  6. Press ENTER.
    The cutting test is performed.


  7. Open the front cover.
  8. Check the results of the cutting test again.