3 Perform a cutting test (separate test for printing/cutting with crop marks).

  1. Set up the media for which operations before cutting output, such as lamination, is complete.
  2. Press ◀ while the following screen is displayed.
    The cutting carriage comes out over the platen.


  3. Press ◀, ▶, ▲ or ▼ to move the center of the blade over the crop marks.
    The center of the blade should only be over the crop marks, and does not need to be aligned with the center of the crop marks.


  4. Once the position has been decided, press FUNCTION to display the screen shown below.


  5. Press ENTER to confirm your entry.
    When the screen displays the character "B" together with the printable width at the location (as shown in the following figure), setting is completed.


  6. Press MENU.
  7. Press ▲ to display the screen shown below.


  8. Press ▶, then ▼ to display the screen shown below.


  9. Press ▶ twice, and then press ▼ once to display the screen shown below.


  10. Press ENTER.
    The cutting test starts.