Table Height Error

Check the table height. Press [OK].

This message is displayed when the head gap sensor interferes with the object during non-printing operations.

Check to see if the object to be printed on does not exceed the size that can be mounted. If it exceeds the size, mount an object to be printed on that is the size that can be mounted.

Tap OK to clear the message.

Operation was stopped because the media height is abnormal. Press [OK].
If the following clearance setting is configured, the flat table is automatically lowered and printing is stopped when an abnormal object height is detected during printing.
  • Clearance Settings: Stop
Check to see if the object to be printed on does not exceed the size that can be mounted. If it exceeds the size, mount an object to be printed on that is the size that can be mounted.

Tap OK to clear the message.

The table height was readjusted. Press [OK].
If the following clearance settings are configured, the flat table height is automatically readjusted and printing resumes when an abnormal object height is detected during printing. When printing is finished, the user is notified that printing has been performed with the flat table height readjusted.
  • Clearance Settings: Readjust
  • Warning Display: Enable

When the message The table height was readjusted. appears, tap OK to clear the message.