Insufficient Media Printing Area

The printing area is insufficient. Set the printing area again.

This message appears when the size of the printing area for the printing test of the nozzle drop-out test or nozzle mask test is larger than the printing area of the loaded object to be printed on.

Tap OK to cancel output. The size of the printing test of the nozzle drop-out test or nozzle mask test is as follows. Increase the size of the printing area to a size larger than this size and perform the printing test again.
  • Nozzle drop-out test: approximately 110 mm (4.33 in.) (width) × approximately 110 mm (4.33 in.) (length)
  • Nozzle mask test: approximately 185 mm (7.28 in.) (width) × approximately 136 mm (5.35 in.) (length)