|
Loading lever |
Use this when loading material. |
|
Left pinch roller |
Lift up the loading lever and then pinch the material with this. Set this at the left edge of the material. |
|
Cutting carriage |
Install the blade holder. This part moves to the left and right to cut the material. |
|
Right pinch roller |
Lift up the loading lever and then pinch the material with this. Set this at the right edge of the material. |
|
Grit roller |
This roller feeds out the material to the front or rear. |
|
Grit pattern |
These indicate the locations of the grit rollers. When loading the material, be sure to place the pinch rollers within the area indicated by each of these patterns. |
|
Blade protector |
This protects the tip of the blade during cutting. |
|
Guide line |
This is a guide for aligning the material when loading. |
|
Knife guide |
By inserting a blade, etc. and moving it along the guide, the material can be cut out without being unloaded. |
|
Operation panel |
You use this to perform various operations. |
