Using Thinner or Harder Material than Normal

Turn on the suction fan to hold the material in place during cutting so as to prevent the material from lifting up or moving out of place. Normally use "AUTO" as is. However, the air volume of the suction fan should be lowered when using materials that are thin and/or not firm.

Procedure
  1. Press [MENU] several times to display the following screen.
    MENU_CONDITION
    MEMO
    When the material is loaded, press [MENU] several times to display the following screen.
    MENU_UNSETUP
  2. Press [▼] several times to display the following screen.
    MENU_OTHERS
  3. Press [▶].
  4. Press [▲][▼] to display the following screen.
    MENU_VACUUMFAN_AUTO
  5. Press [▶].
  6. Press [▲] or [▼] to select a value.

    Use a weaker air volume when using thin material.

    MENU_VACUUMFAN_AUTO_AUTO
  7. Press [ENTER] to select the setting.
  8. Press [MENU] to return to the original screen.
    MEMO
    • Factory default setting: "AUTO"
    • Setting range: 1 to 5, "AUTO"