Step 6: Cutting

Send Print & Cut data to the machine, and start cutting.
WARNING

Never touch the cutting carriage while output is in progress.

The cutting carriage moves at high speed. Coming into contact with the moving carriage may cause injury.

Procedure
  1. Click Icon_CutStudio_Cut.

    The Cut window is displayed.

    CutStudio_Cutting
  2. Click OK.
    The Print & Cut data is sent to the machine. When the machine receives the Print & Cut data, it automatically reads the crop marks using a sensor, and then starts cutting.
    CutStudio_Cut_OK_01
    MEMO

    If the sensor fails to read the crop marks, the screen shown below appears.

    If the following screen appears, refer to Crop Marks Are Not Detected to resolve the error.

    MENU_SET-TO-TOOLMODE

    If that does not resolve the issue, switch to Tool Mode, and then perform aligning. Print & Cut in Tool Mode

  3. Remove the cut material.