Step 4: Cutting (Manual Mode)

WARNING

Never touch the cutting carriage while output is in progress.

The cutting carriage moves at high speed. Coming into contact with the moving carriage may cause injury.

Procedure
  1. Press [◀], then [▼] to display the screen shown below.

    For 3 tool marks, select "3-POINT START".

    MENU_MANUAL_4-POINT-START
  2. Press [ENTER].
    The screen shown below appears.
    MENU_REPLACE-TO-TOOL_QUIT_MENU
  3. Remove the blade holder and install the alignment tool.

    The alignment tool can be installed in the same manner as the blade holder.

    GS2_AlignmenttoolSet
  4. Press [ENTER].
    The screen shown below appears.
    MENU_MARK1-SET_RETURN_MENU
  5. Press [▲][▼][◀][▶], and align the tip of the alignment tool with tool mark 1.

    Hold down the alignment tool gently from above with your finger and check that the tip of the alignment tool overlaps the tool mark.

    GS2_Alignmenttool-mark_manual1
  6. Press [ENTER].
    The tool moves to a position near the lower-right tool mark, and then the screen shown below appears.
    MENU_MARK2-SET_RETURN_MENU
  7. Press [▲][▼][◀][▶], and align the tip of the alignment tool with tool mark 2.
    MEMO To perform aligning again, press [MENU] during setup to return to the previous screen, and perform the procedure again.
    GS2_Alignmenttool-mark_manual2
  8. Press [ENTER].
    The tool moves to a position near the upper-left tool mark, and then the screen shown below appears.
    MENU_MARK3-SET_RETURN_MENU
  9. Align tool marks 3 and 4 in the same way.
    GS2_Alignmenttool-mark_manual3
  10. After aligning tool mark 4, press [ENTER].
    The screen shown below appears.
    MENU_REPLACE-TO-BLADE_RETURN_MENU
  11. Remove the alignment tool and install the blade holder.
    GS2_BladeHolder_3
  12. Press [ENTER].
  13. Press [ENTER] when the following screen appears.
    MENU_COMPLETE_ENTER_QUIT_MENU
  14. When the screen shown below is displayed, send cut data from the computer.
    MENU_OUTPUT-DATA

    When the machine receives the data, it starts cutting.

  15. Remove the cut material.