2. Load the printed material
Load the material printed from a printer to the machine.
IMPORTANT Curled material cannot be used, as crop marks may not be readable. If material curls when printed, straighten it out before loading it onto the machine.
Procedure
- Check the origin for cutting () on the material.
-
Set the material by positioning its origin for cutting to the bottom left of the machine.
-
Position the pinch rollers.
MEMO
-
Align the left edge of the material so that it lies approximately parallel to the guide line ().
-
Raise the loading lever.
The material is secured in place.
- Turn on the machine.
- Select PIECE as the type of material.
-
Press [ENTER].
The cuttable width and length are displayed.
-
Press [▲][▼] to move the material and position the crop mark () above the blade protector ().
- Press [◀][▶] to move the cutting carriage so that the tip of the blade comes over the center of the lower-left crop mark.