Setting the Blade Force

If the design peels off or if the carrier paper is also cut with the material, change the blade force.
Procedure
  1. Check that the PEN FORCE slider [PEN FORCE] is at the center position (at "0" on the scale).
    GS2_PenForth-Position
  2. Press [FORCE].

    The current blade force is displayed.

    MENU_FORCE_50gf_200gf
  3. Press [▲] or [▼] to select a value.
  4. Press [ENTER] to select the setting.
    MEMO
    • Factory default setting: 50 gf
    • Setting range: 30 to 500 gf (can be changed in 10 gf steps)

Fine-tuning the Blade Force

After you set the blade force using the "FORCE" menu, you can further fine-tune the blade force using the PEN FORCE slider. "FORCE"Use this operation when you want to make the blade force slightly larger or smaller than the setting made using the menu.

Procedure
Adjust the blade force with the PEN FORCE slider.
GS2_PenForth-adjustment
  • Adjustable range: ±Approximately 30 gf
MEMO The value adjusted here is only a rough guide. The accuracy of this value is not guaranteed.