"CONDITION"

Here, cutting conditions including blade force and cutting speed are set and confirmed. The settings affect the cutting quality. Change the cutting conditions according to the material you are using.

• "FORCE"

  • 
  • The blade force can be set. If the design peels off or if the carrier paper is also cut together with the material, change the setting of "FORCE". Setting the Blade Force

• "SPEED"

  • 
  • The cutting speed can be set. If the cutting line is distorted or if partial uncut areas remain, change the setting of "SPEED". Setting the Cutting Speed

• "OFFSET"

  • 
  • The blade tip offset can be set. If the beginning of a cut deviates from the intended location or if the corners of a shape are not clean, change the setting of "OFFSET". Setting the Blade Tip Offset Amount

• "UPSPEED"

  • 
  • The speed for lifting the blade off the material and moving it to the next cutting position during cutting operation can be set. When cutting material that is thinner or thicker than the standard material, change the setting of "UPSPEED" to prevent problems such as material being lifted up.Setting the Speed of the Blade During Cutting

• "ROTATE"

  • 
  • Cutting coordinates can be rotated, and the cutting direction of the material can be set.
  • Set the Orientation of Cutting Coordinates

• "QUALITY"

  • 
  • The cutting quality can be set. In cases such as using thick material, change the setting of "QUALITY".

• "EXTEND"

  • 
  • You can set whether to extend the cutting area compared to the normal setting or not. To maximize the use of material, change the setting of "EXTEND".
  • Extending the Cutting Area

• "AREA"

  • 
  • When using roll material, the length of the required material can be set. When setting up roll material, change the setting of "AREA".
  • 3. Check Material Feeding