Step 4: Setting the Output-start Location

Before cutting, set the output-start location to a location where adequate cutting area can be secured.

Output the actual cutting to an area that does not overlap with the area used for cutting tests.

Procedure
  1. Press [◀][▲] to move the cutting carriage to the location you want to set as the origin.

    Move the cutting carriage until the blade tip points to the location you want to set as the origin.

    GS2_OriginPoint-Set_1
  2. Press [▲] to move the material backward, and ensure that the cutting test traces are in front of the blade protector.

    The blade moves over the blade protector. When the origin is set, the area behind the blade protector is set as the cutting area.

    GS2_OriginPoint-Set_2
  3. Hold down [ORIGIN] for one second or longer.
    The display flashes, and the location of the blade tip is set as the origin.