Preventing Misaligned Cutting

Material is automatically fed before and during cutting in order to avoid misalignment of cutting positions. If this is set as "ON", the material is automatically fed forward for 1 m (3.28 ft.) whenever the computer sends out cut data (depending on the data, the material may be fed out 1 m (3.28 ft.) or more), then the cutting starts.
MEMO If material has already been fed out using the "AREA" function, the material will not be fed out automatically for the amount that has already been fed out, even if "PRE-FEED" is set to "ON".
Procedure
  1. Press [MENU] several times to display the following screen.
    MENU_CONDITION
    MEMO
    When the material is loaded, press [MENU] several times to display the following screen.
    MENU_UNSETUP
  2. Press [▼] several times to display the following screen.
    MENU_OTHERS
  3. Press [▶].
  4. Press [▲][▼] to display the following screen.
    MENU_PRE-FEED_OFF
  5. Press [▶].
  6. Press [▲] or [▼] to select "ON" or "OFF".
    MENU_PRE-FEED_OFF_OFF
  7. Press [ENTER] to select the setting.
  8. When "ON" is selected, set the material feeding speed.
    1. Press [▶] twice to display the screen shown below.
      MENU_SPEED_40cms
    2. Press [▶].
    3. Press [▲] or [▼] to select a value.
    4. Press [ENTER] to select the setting.
  9. Press [MENU] to return to the original screen.
    MEMO
    • Factory default setting: "OFF"
    • Setting range: "ON" (1 to 10 cm/s) (0.40 to 3.93 in./s), "OFF"