Setting the Up Speed for Cutting

This setting lets you set the speed for moving the blade to the next cutting position with the blade lifted off the material during cutting operation. Using a faster up speed can shorten output time. If the material comes loose during no-load feeding and the blade damages the surface of the material, reduce the speed.
Procedure
  1. Press [SPEED].
    If material is loaded, press [ON/OFF LINE] to switch to offline mode.
  2. Press [▶] several times to display the screen shown below.

    The current value is displayed on the screen.


    MENU_Speed_Upspeed

  3. Press [▲] or [▼] to set the up speed for moving the blade to the next cutting data.
  4. Press [ENTER] to confirm your entry.
  5. Press [ON/OFF LINE] to go back to the original screen.
    MEMO
    • Default setting: 72 cm/s (28.34 in./s)
    • Setting range: 3 to 153 cm/s (1.18 to 60.23 in./s) (changeable in 3 cm/s [1.18 in./s] increments)